![]() If this does not work, you can heat up the original startīutton slightly with a hairdryer set on Low before attaching the rubber. Trying to pull out the original start button. Rubber set for about 5 minutes after you have attached and formed it, before Start/Stop Button: It is recommended that you let the sticky If you have a leased car and are concerned about restoring the OEM iDriveĬontroller, you may want to leave the adhesive film on the printed circuit The reason the instructions say to remove both the touchpad surface layer and the adhesive film under is to achieve a tightįit. When installing the ring, it is important not to use force. The ring onlyįits in one position, with the cutout next to the U section. Printed circuit board can break off if the We recommend unplugging it to ensure a safe Some customers prefer to unplug the ribbonĬable, while others prefer not to. Pliers/cloth while pulling out the button. ![]() Method: First heat up OEM button slightly with a hair dryer, then melt end of a Other methods:3) Drill a hole in the OEM button, fasten a screw in the holeĪnd pull the button out with pliers, or insert a small Allen wrench in the hole The printer paper double for the second screwdriver step is recommended. Again, be very careful so you don't dent the trim ring. Removing OEM button with two screwdrivers and a piece of printer paper ( see If the trim ring does not come off: check alternate methods below.Ģ. Don't press on the pliers too hard, don't pull, just wiggle back and forth Use a thick piece of cloth and pliers that are not Be very careful when you remove the ring, so you don't dent it. Removing trim ring with pliers and cloth ( see video 1). There are two recommended methods for installation:ġ. WARNING ! Position cable correctly in connector! Installation times can be lowered by installing multiple products together. Very easy and 10 is difficult (10 = workshop installation required). Instructions for disassembling center console and using BMW Repair Manualĭifficulty for the installation is measured on a scale from 1 to 10, where 1 is How to do it in your car, see links below: Shift Knob with Ambient Light below shows how it is done in a X5. Required to remove the gear console from the car. Volume Button can be installed without removing the audio panel from the Not necessary to remove the gear console from the car. The iDrive controller has to be replaced.įor installation of the Crystal Start/Stop Button, it's It has to be towed to a workshop and have the gear consoleĬontroller can be damaged in a similar way when installing the Crystal The correct position when the cable lock is closed, a short circuit can occur inĬonsole when it is reconnected to power. ![]() Warning:If the gear shift knob cable is not in ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |